Altera cyclone V Technical Reference page 400

5-206
GPLMUX39
GPLMUX39
Selection between GPIO and LoanIO output and output enable for GPIO39 and LoanIO39. These signals
drive the Pin Mux. The Pin Mux must be configured to use GPIO/LoanIO in addition to these settings
Only reset by a cold reset (ignores warm reset). NOTE: These registers should not be modified after IO
configuration.There is no support for dynamically changing the Pin Mux selections.
Module Instance
sysmgr
Offset:
0x670
Access:
RW
Important: To prevent indeterminate system behavior, reserved areas of memory must not be accessed by
31 30
15 14
GPLMUX39 Fields
Bit
0
sel
GPLMUX40
Selection between GPIO and LoanIO output and output enable for GPIO40 and LoanIO40. These signals
drive the Pin Mux. The Pin Mux must be configured to use GPIO/LoanIO in addition to these settings
Only reset by a cold reset (ignores warm reset). NOTE: These registers should not be modified after IO
configuration.There is no support for dynamically changing the Pin Mux selections.
Module Instance
sysmgr
Offset:
0x674
Altera Corporation
software or hardware. Any area of the memory map that is not explicitly defined as a register
space or accessible memory is considered reserved.
29 28 27 26
13 12 11 10
Name
Select source for GPIO/LoanIO 39. 0 : LoanIO 39
controls GPIO/LOANIO[39] output and output
enable signals. 1 : GPIO 39 controls GPIO/
LOANI[39] output and output enable signals.
Base Address
0xFFD08000
Bit Fields
25 24 23 22
Reserved
9 8 7 6
Reserved
Description
Base Address
0xFFD08000
Register Address
0xFFD08670
21 20 19 18
5 4 3 2
Access
Register Address
0xFFD08674
cv_5v4
2016.10.28
17 16
1 0
sel
RW 0x0
Reset
RW 0x0
System Manager
Send Feedback