Altera cyclone V Technical Reference page 320

5-126
FLASHIO11
FLASHIO10 Fields
Bit
1:0
sel
FLASHIO11
This register is used to control the peripherals connected to sdmmc_d3 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
Module Instance
sysmgr
Offset:
0x47C
Access:
RW
Important: To prevent indeterminate system behavior, reserved areas of memory must not be accessed by
31 30
15 14
FLASHIO11 Fields
Bit
1:0
sel
Altera Corporation
Name
Select peripheral signals connected sdmmc_d2. 0 :
Pin is connected to GPIO/LoanIO number 46. 1 : Pin
is connected to Peripheral signal not applicable. 2 :
Pin is connected to Peripheral signal USB0.DIR. 3 :
Pin is connected to Peripheral signal SDMMC.D2.
software or hardware. Any area of the memory map that is not explicitly defined as a register
space or accessible memory is considered reserved.
29 28 27 26
13 12 11 10
Name
Select peripheral signals connected sdmmc_d3. 0 :
Pin is connected to GPIO/LoanIO number 47. 1 : Pin
is connected to Peripheral signal not applicable. 2 :
Pin is connected to Peripheral signal USB0.NXT. 3 :
Pin is connected to Peripheral signal SDMMC.D3.
Description
Base Address
0xFFD08000
Bit Fields
25 24 23 22
Reserved
9 8 7 6
Reserved
Description
Access
Register Address
0xFFD0847C
21 20 19 18
5 4 3 2
Access
cv_5v4
2016.10.28
Reset
RW 0x0
17 16
1 0
sel
RW 0x0
Reset
RW 0x0
System Manager
Send Feedback