Altera cyclone V Technical Reference page 869

13-48
multiplane_operation
multiplane_operation
Multiplane transfer mode. Pipelined read, copyback, erase and program commands are transfered in
multiplane mode
Module Instance
nandregs
Offset:
0x70
Access:
RW
Important: To prevent indeterminate system behavior, reserved areas of memory must not be accessed by
31 30
15 14
multiplane_operation Fields
Bit
0
flag
multiplane_read_enable
Device supports multiplane read command sequence
Module Instance
nandregs
Offset:
0x80
Access:
RW
Important: To prevent indeterminate system behavior, reserved areas of memory must not be accessed by
Altera Corporation
software or hardware. Any area of the memory map that is not explicitly defined as a register
space or accessible memory is considered reserved.
29 28 27 26
13 12 11 10
Name
[list][*]1 - Multiplane operation enabled [*]0 -
Multiplane operation disabled[/list]
software or hardware. Any area of the memory map that is not explicitly defined as a register
space or accessible memory is considered reserved.
Base Address
0xFFB80000
Bit Fields
25 24 23 22
Reserved
9 8 7 6
Reserved
Description
Base Address
0xFFB80000
Register Address
0xFFB80070
21 20 19 18
5 4 3 2
Access
Register Address
0xFFB80080
NAND Flash Controller
cv_5v4
2016.10.28
17 16
1 0
flag
RW 0x0
Reset
RW 0x0
Send Feedback