Altera cyclone V Technical Reference page 317

cv_5v4
2016.10.28
FLASHIO6 Fields
Bit
1:0
sel
FLASHIO7
This register is used to control the peripherals connected to sdmmc_d7 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
Module Instance
sysmgr
Offset:
0x46C
Access:
RW
Important: To prevent indeterminate system behavior, reserved areas of memory must not be accessed by
31 30
15 14
FLASHIO7 Fields
Bit
1:0
sel
System Manager
Send Feedback
Name
Select peripheral signals connected sdmmc_d6. 0 :
Pin is connected to GPIO/LoanIO number 42. 1 : Pin
is connected to Peripheral signal not applicable. 2 :
Pin is connected to Peripheral signal USB0.D6. 3 : Pin
is connected to Peripheral signal SDMMC.D6.
0xFFD08000
software or hardware. Any area of the memory map that is not explicitly defined as a register
space or accessible memory is considered reserved.
29 28 27 26
13 12 11 10
Name
Select peripheral signals connected sdmmc_d7. 0 :
Pin is connected to GPIO/LoanIO number 43. 1 : Pin
is connected to Peripheral signal not applicable. 2 :
Pin is connected to Peripheral signal USB0.D7. 3 : Pin
is connected to Peripheral signal SDMMC.D7.
Description
Base Address
Bit Fields
25 24 23 22
Reserved
9 8 7 6
Reserved
Description
FLASHIO7
Access
Register Address
0xFFD0846C
21 20 19 18
5 4 3 2
Access
5-123
Reset
RW 0x0
17 16
1 0
sel
RW 0x0
Reset
RW 0x0
Altera Corporation