Altera cyclone V Technical Reference page 287

cv_5v4
2016.10.28
GENERALIO2
This register is used to control the peripherals connected to trace_d1 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO3
This register is used to control the peripherals connected to trace_d2 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO4
This register is used to control the peripherals connected to trace_d3 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO5
This register is used to control the peripherals connected to trace_d4 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO6
This register is used to control the peripherals connected to trace_d5 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO7
This register is used to control the peripherals connected to trace_d6 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO8
This register is used to control the peripherals connected to trace_d7 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO9
This register is used to control the peripherals connected to spim0_clk Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO10
This register is used to control the peripherals connected to spim0_mosi Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO11
This register is used to control the peripherals connected to spim0_miso Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
GENERALIO12
This register is used to control the peripherals connected to spim0_ss0 Only reset by a cold reset (ignores
warm reset). NOTE: These registers should not be modified after IO configuration.There is no support for
dynamically changing the Pin Mux selections.
System Manager
Send Feedback
on page 5-128
on page 5-129
on page 5-130
on page 5-130
on page 5-131
on page 5-132
on page 5-133
on page 5-133
on page 5-134
on page 5-135
on page 5-136
Pin Mux Control Group Register Descriptions
5-93
Altera Corporation