11-36
Enabling Simple Memory Test
Enabling Simple Memory Test
After the SDRAM is successfully calibrated, a simple memory test may be performed using the debugger.
1. When you create the
window..
2. The simple memory test assumes SDRAM with a memory size of 1 GB. If your board contains a
different SDRAM memory size, open the file
Altera Corporation
file in the BSP Editor, select HARDWARE_DIAGNOSTIC in the spl.debug
.bsp
<design folder>\spl_bsp\uboot-socfpga\
cv_5v4
2016.10.28
SDRAM Controller Subsystem
Send Feedback