Enabling Simple Memory Test - Altera Cyclone V Device Handbook

Hide thumbs Also See for Cyclone V:

Table of Contents

2. You must also enable semihosting in the debugger, by typing set semihosting enabled true

at the command line in the debugger.

Enabling Simple Memory Test

To enable the simple memory test, follow these steps:

1. When you create the

window to enable the simple memory test.

SDRAM Controller Subsystem

Send Feedback

file in the BSP Editor, turn on HARDWARE_DIAGNOSTIC in the spl.debug

Enabling Simple Memory Test

Altera Corporation

Table of Contents