Document Revision History - Altera Cyclone V Device Handbook

CV-53007
2013.05.06
• Switching between a receiver-only channel and a transmitter-only channel
• Switching between bonded to non-bonded mode or bonded mode with different xN lanes count (for
example, switching from bonded x2 to bonded x4)
• Switching between one PHY IP to another PHY IP (for example Deterministic Latency PHY IP to Custom
PHY IP)
• TX PLL reconfiguration is not supported if the TX PLL is connected to bonded channels
You can achieve PHY to PHY IP reconfiguration only if you use the Native PHY IP to configure your
transceiver. For example, if you use the Native PHY IP to configure the SDI mode and a custom proprietary
IP mode (also configured using Native PHY IP), you can reconfigure these two modes within the Native
PHY IP. The switching refers to enabling and disabling the PCS sub-blocks for both SDI and the custom
proprietary IP mode.

Document Revision History

May 2013
November 2012
Dynamic Reconfiguration in Cyclone V Devices
Send Feedback
Date Version
2013.05.06
2012.11.19
Document Revision History
Changes
• Updated TX DCD calibration
information
• Included link AN 661 for fPLL
reconfiguration
• Added link to the known document
issues in the Knowledge Base.
• Rewritten and reorganized content,
and updated template
• Added TX DCD
• Added Transceiver PLL Reconfigu-
ration
• Transceiver Channel Reconfigura-
tion
• Listed unsupported features
7-7
Altera Corporation