Altera Cyclone V Device Handbook page 465

cv_54001
2013.12.30
Related Information
Ethernet Media Access Controller
USB Controllers
The two USB 2.0 On-The-Go (OTG) controllers are based on the Synopsys DesignWare Cores USB 2.0 Hi-
Speed On-The-Go controller and offer the following features:
• Supports USB 2.0 host and device operation
• Dual-role device (device and host functions)
• High-speed (480 Mbps)
• Full-speed (12 Mbps)
• Low-speed (1.5 Mbps)
• Supports USB 1.1 (full-speed & low-speed)
• Integrated descriptor-based scatter-gather DMA (SGDMA)
• Support for external ULPI PHY
• Up to 16 bidirectional endpoints, including control endpoint
• Up to 16 host channels
• Supports generic root hub
• Automatic ping capability
• Configurable to OTG 1.3 and OTG 2.0 modes
Related Information
USB 2.0 OTG Controller
2
I C Controllers
The four I
features:
• Two controllers support I
control
• Support both 100 KBps and 400 KBps modes
• Support both 7-bit and 10-bit addressing modes
• No support for mixed-address mode
• Support master and slave operating mode
• Direct access for host processor
• DMA controller may be used for large transfers
Related Information
2
I C Controller
Introduction to Cyclone V Hard Processor System (HPS)
Send Feedback
on page 18-1
2
C controllers are based on Synopsys DesignWare APB I
2
C management interfaces for the EMAC controllers which are for Ethernet
on page 20-1
on page 17-1
USB Controllers
2
C controller and offer the following
1-9
Altera Corporation