Enabling The Debug Report - Altera Cyclone V Device Handbook

Hide thumbs Also See for Cyclone V:

Table of Contents

Enabling the Debug Report

You can enable the SDRAM calibration sequencer to produce a debug report on the UART printout or

semihosting output. To enable the debug report, follow these steps:

1. After you have enabled the UART or semihosting, open the file <project directory>\

2. Locate the line #define RUNTIME_CAL_REPORT 0 and change it to #define

RUNTIME_CAL_REPORT 1.

Figure 8-7: Semihosting Printout With Debug Support Enbled

Analysis of Debug Report

The following analysis will help you interpret the debug report.

SDRAM Controller Subsystem

Send Feedback

in a text editor.

sequencer_defines.h

Enabling the Debug Report

Altera Corporation

Table of Contents