Altera Cyclone V Device Handbook page 140

CV-52005
2014.01.10
I/O banks that do not have calibration blocks share the calibration blocks in the I/O banks that have
calibration blocks.
All I/O banks support OCT calibration with different V
OCT calibration blocks.
You can configure the I/O banks to receive calibration codes from any OCT calibration block with the same
V . If a group of I/O banks has the same V
CCIO
the group of I/O banks placed around the periphery.
Related Information
OCT Calibration Block Sharing Example
Dynamic Calibrated On-Chip Termination (ALTOCT) Megafunction User Guide
Provides more information about the OCT calibration block.
OCT Calibration Block Sharing Example
Figure 5-19: Example of Calibrating Multiple I/O Banks with One Shared OCT Calibration Block
As an example, this figure shows a group of I/O banks that has the same V
show transceiver calibration blocks.
Because banks 5A and 7A have the same V
and 7A) with the OCT calibration block (CB3) located in bank 3A.
To enable this calibration, serially shift out the R
in bank 3A to the I/O banks around the periphery.
Related Information
Sharing an OCT Calibration Block on Multiple I/O Banks
I/O Features in Cyclone V Devices
Send Feedback
voltage, you can use one OCT calibration block to calibrate
CCIO
on page 5-43
Bank 8A
Bank 3A Bank 3B
CB3
as bank 3A, you can calibrate all three I/O banks (3A, 5A,
CCIO
OCT calibration codes from the OCT calibration block
S
OCT Calibration Block Sharing Example
voltage standards, up to the number of available
CCIO
CCIO
Bank 7A
I/O bank with different V
CCIO
I/O bank with the same V
CCIO
Bank 4A
on page 5-42
5-43
voltage. The figure does not
Altera Corporation