Support Peripherals - Altera Cyclone V Device Handbook

cv_54001
2013.12.30

Support Peripherals

Clock Manager
The clock manager offers the following features:
• Manages clocks for HPS
• Supports dynamic clock tuning
Related Information
Clock Manager
Reset Manager
The reset manager offers the following features:
• Manages resets for HPS
Related Information
Reset Manager
System Manager
The system manager offers the following features:
• ECC monitoring and control
• Pin multiplexing
• Low-level control of peripheral features not accessible through the control and status registers (CSRs)
• Freeze controller that places I/O elements into a safe state for configuration
Related Information
System Manager
Scan Manager
The scan manager offers the following features:
• Drives serial scan-chains to FPGA JTAG and HPS I/O bank configuration
Related Information
Scan Manager
Timers
The four timers are based on the Synopsys DesignWare APB Timers peripheral and offer the following
features:
• 32-bit timer resolution
• Free-running timer mode
• Programmable time-out period up to approximately 86 seconds (assuming a 50 MHz input clock
frequency)
• Interrupt generation
Related Information
Timer Introduction
Introduction to Cyclone V Hard Processor System (HPS)
Send Feedback
on page 2-1
on page 3-1
on page 14-1
on page 15-1
on page 23-1
1-7
Support Peripherals
Altera Corporation