ADTRAN AOS Version R10.1.0 Command Reference Manual page 680

Command Reference Guide
show modules
The show modules command displays information on the current system setup. Variations of this
command include:
show modules
show modules verbose
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
verbose
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Release 17.1
Usage Examples
The following example displays the modules installed in the unit.
>enable
#show modules
Slot Ports Type
0 3 NetVanta 5305
1 1 T3 Module
2 - Empty
3 - Empty
4 - Empty
5 - Empty
6 - Empty
7 - Empty
60000CRG0-35E
Optional. Enables detailed messaging.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Serial # Part #
*********** 1200990L1
*********** 1200832L1
----------- -----------
----------- -----------
----------- -----------
----------- -----------
----------- -----------
----------- -----------
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
H/W Rev
A
A
----------
----------
----------
----------
----------
----------
680