ADTRAN AOS Version R10.1.0 Command Reference Manual page 217

Command Reference Guide
copy xmodem
Use the copy xmodem command to copy a file (using the XMODEM protocol) to a specified destination.
XMODEM capability is provided in VT100 terminal emulation software, such as HyperTerminal.
Variations of this command (valid only on AOS units WITH CompactFlash
copy xmodem cflash
Variations of this command (valid only on AOS units WITH CompactFlash AND voice capability)
include:
copy xmodem dynvoice-config
Variations of this command (valid only on AOS units WITH ramdisk enabled) include:
copy xmodem ramdisk
Variations of this command (valid only on AOS units WITH Universal Serial Bus (USB) flash drive
capability) include:
copy xmodem usbdrive0
Variations of this command (valid on all AOS units) include:
copy xmodem flash
copy xmodem running-config
copy xmodem startup-config
Syntax Description
cflash
dynvoice-config
flash
ramdisk
60000CRG0-35E
Copies a file from the terminal connected to the console port and saves it to
the CompactFlash card.
After entering copy xmodem cflash, AOS prompts for the following
information:
Destination filename:
Specifies that the file copied from the terminal connected to the console port
overwrite the dynamic voice configuration file.
Copies a file from the terminal connected to the console port and saves it to
flash memory.
After entering copy xmodem flash, AOS prompts for the following
information:
Destination filename:
Copies a file from the terminal connected to the console port and saves it to
the volatile RAM disk.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
®
capability) include:
Specifies the file name to use when storing the
copied file to cflash memory.
Specifies the file name to use when storing the
copied file to flash memory.
217