ADTRAN AOS Version R10.1.0 Command Reference Manual page 489

Command Reference Guide
Command History
Release 17.4
Release A4.01
Release A5.01
Functional Notes
For more information regarding Ethernet OAM CFM and its operation on AOS products, refer to the
Ethernet OAM CFM in AOS configuration guide available online at
(article number 3013).
Usage Examples
The following is sample output from the show ethernet cfm mep local detail command:
>enable
#show ethernet cfm mep local detail
MEPs configured on this device
MEP-ID: 3
Domain/Assoc: BenchTest/Test
Mac Address: 00:A0:C9:00:D8:B2 Interface: giga-eth 0/2 Vlan:
Level: 5
Admin State: up
Fault Notification Settings
-----------------------------------------------
Highest Allowed Defect: MacStatus
AlarmTime: 2500 ms
SNMP Trap: Disabled
Current Fault State
-----------------------------------
Fault State: Defect Last Reported Fault: 08:41 PM, 09/16/2008
Current Highest Defect: None
Current Defects (Highest to Lowest defect priority):
Xcon CCM: -
Err'd CCM: -
Remote CCM: -
MAC Status: -
RDI: -
Message Statistics
-----------------------------------
CCMs Transmitted: 2787 CCMs Received Out of Sequence: 4
LBRs Transmitted: 0
60000CRG0-35E
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the Gigabit Ethernet interface.
Direction: down Priority: 7
CCM State: yes
ResetTime: 10000 ms
Next LBM ID:
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
https://supportforums.adtran.com
0
36
489