ADTRAN AOS Version R10.1.0 Command Reference Manual page 523

Command Reference Guide
show interfaces <interface>
Use the show interfaces command to display configuration parameters and current statistics for all
interfaces (or a specified interface). Variations of this command include the following:
show interfaces <interface>
show interfaces <interface> extended
show interfaces <interface> performance-statistics
show interfaces <interface> performance-statistics <x-y>
show interfaces <interface> performance-statistics total-24-hour
show interfaces <interface> realtime
show interfaces <interface> verbose
show interfaces <interface> version
Not all subcommands apply to all interfaces. Type show interfaces <interface> ? for a list
of valid subcommands for the specified interface.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Using the realtime argument for this command can adversely affect the performance of
your unit.
Syntax Description
<interface>
extended
performance-statistics
<x-y>
total-24-hour
realtime
60000CRG0-35E
Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show interfaces ? for a complete list of valid
interfaces.
Optional. Displays extende medium attachment unit (MAU) statistics.
Optional. Displays all 96 stored intervals.
Optional. Shows a specified interval (x) or range of intervals (x-y).
Optional. Displays the current 24-hour totals.
Optional. Displays full-screen output in real time. Refer to the Functional
Notes below for more information.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
523