ADTRAN AOS Version R10.1.0 Command Reference Manual page 1019

Command Reference Guide
ip firewall vrf <name>
Use the ip firewall vrf command to enable the firewall for a particular Internet Protocol version 4 (IPv4)
VPN routing and forwarding (VRF) instance. The IPv4 firewall can be enabled or disabled independently
for each VRF. Firewall settings are applied globally across all VRF instances and cannot be changed on an
individual VRF basis. Refer to the command
IPv4 firewall settings. Use the no form of this command to disable the firewall for the specified VRF.
Syntax Description
<name>
Default Values
By default, the IPv4 firewall is disabled.
Command History
Release 17.1
Functional Notes
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured.
Usage Examples
The following example enables the IPv4 firewall on the VRF named RED:
(config)#ip firewall vrf RED
60000CRG0-35E
ip firewall on page 999
Specifies the VRF instance.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
for more information on configuring
1019