ADTRAN AOS Version R10.1.0 Command Reference Manual page 536

Command Reference Guide
show interface shdsl <slot/port> splice-detect
Use the show interface shdsl splice-detect command to view the bad splice detection test results for the
specified interface. Variations of this command include:
show interface shdsl <slot/port> splice-detect 24-hour
show interface shdsl <slot/port> splice-detect 24-hour <interval>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<slot/port>
splice-detect 24-hour
<interval>
Default Values
No default values are necessary for this command.
Command History
Release A4.05
Usage Examples
The following example displays the bad splice detection test results for SHDSL interface 1/1 over the past
24 hours:
#show interface shdsl 1/1 splice-detect 24-hour
Current Splice Detect Data
Summary: No Trouble Found
Distance (ft) Count
0 0
200 0
400 0
600 0
800 0
1000 0
1200 0
60000CRG0-35E
Specifies the slot and port of the interface on which the test was run.
Displays the bad splice detection test results for the last 24 hours.
Optional. Specifies that results from one or more of the previous 24-hour
intervals are displayed. Valid interval range is 1 to 7. You can enter a single
interval, or a range of intervals when separated by a dash.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
536