ADTRAN AOS Version R10.1.0 Command Reference Manual page 437

Command Reference Guide
Usage Examples
The following are output variations of the show bgp ipv4 neighbors command:
>enable
#show bgp ipv4 neighbors
BGP neighbor is 10.15.43.17, remote AS 100, external link
Configured hold time is 180, keepalive interval is 60 seconds
Default minimum time between advertisement runs is 30 seconds
Connections established 6; dropped 5
Last reset: Interface went down
Connection ID: 15
BGP version 4, remote router ID 8.1.1.1
BGP state is Established, for 01:55:05
Negotiated hold time is 180, keepalive interval is 60 seconds
Message statistics:
InQ depth is 0, OutQ depth is 0
Local host: 10.15.43.18, Local port: 179
Sent Rcvd
Opens:1 1
Notifications: 00
Updates: 0 8
Keepalives: 116116
Unknown: 0 0
Total: 117 125
Foreign host: 10.15.43.17, foreign port: 1048
Flags: passive open
#show bgp ipv4 neighbors 10.15.43.34 advertised-routes
BGP local router ID is 10.0.0.1, local AS is 101.
Status codes: * valid, > best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete
NetworkNextHopMetric Path
*> 1.0.0.0/810.15.43.171 100 i
*> 2.0.0.0/910.15.43.171 100 i
#show bgp ipv4 neighbors 10.15.43.17 received-routes
BGP local router ID is 10.0.0.1, local AS is 101.
Status codes: * valid, > best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete
NetworkNextHopMetric Path
*> 1.0.0.0/810.15.43.171 100 i
*> 2.0.0.0/910.15.43.171 100 i
60000CRG0-35E Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
437