Show Ipv6 Routers - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ipv6 routers

Use the show ipv6 routers command to display information learned from router advertisement (RA)
messages received from locally reachable routers when using Internet Protocol version 6 (IPv6).
Variations of this command include:
show ipv6 routers
show ipv6 routers conflict
show ipv6 routers <interface>
show ipv6 routers <interface> conflict
show ipv6 routers vrf <name>
show ipv6 routers vrf <name> conflict
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
conflict
<interface>
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 18.1
Release R10.1.0
Functional Notes
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured. Therefore, executing the abovementioned commands without
specifying a VRF will only affect the default unnamed VRF.
60000CRG0-35E
Optional. Specifies that only information about routers whose
advertisements are in conflict with current configurations are displayed.
Optional. Displays information for the specified interface. Specify interfaces
in the <interface> <slot/port | interface id> format. For example, to specify a
Point-to-Point Protocol (PPP) interface, enter ppp 1.
Optional. Displays only the IPv6 routes for the specified VPN routing and
forwarding (VRF) instance. If no VRF is specified, information for the default
VRF is displayed.
Command was introduced.
Command was expanded to include the tunnel interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
640