ADTRAN AOS Version R10.1.0 Command Reference Manual page 702

Command Reference Guide
show pppoe
Use the show pppoe command to display all Point-to-Point Protocol over Ethernet (PPPoE) settings and
associated parameters.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Release 17.1
Usage Examples
The following example enters the Enable mode and uses the show command to display PPPoE
information:
>enable
#show pppoe
ppp 1
Outgoing Interface: eth 0/1
Outgoing Interface MAC Address: 00:A0:C8:00:85:20
Access-Concentrator Name Requested: FIRST VALID
Access-Concentrator Name Received: 13021109813703-LRVLGAOS90W_IFITL
Access-Concentrator MAC Address: 00:10:67:00:1D:B8
Session Id: 64508
Service Name Requested: ANY
Service Name Available:
PPPoE Client State: Bound (3)
Redial retries: unlimited
Redial delay: 10 seconds
Backup enabled all day on the following days:
Sunday Monday Tuesday Wednesday Thursday Friday Saturday
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
702