ADTRAN AOS Version R10.1.0 Command Reference Manual page 569

Command Reference Guide
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<area id>
adv-router <ip address>
database-summary
external
network
router
summary
<link-state id>
Default Values
No default values are necessary for this command.
Command History
Release 3.1
Release 17.1
60000CRG0-35E
Optional. Specifies an OSPF area ID. Refer to
<wildcard mask> area <area id> on page 3005
Optional. Displays information about link state advertisements (LSAs) from
the specified advertising router IP address. IP addresses should be
expressed in dotted decimal notation (for example, 10.10.10.1).
Optional. Displays a simplified list of LSAs for the specified area.
Optional. Displays information about external LSAs from the specified
link-state ID.
Optional. Displays information about network LSAs for the specified area or
from the specified link-state ID.
Optional. Displays information about router LSAs for the specified area or
from the specified link-state ID.
Optional. Displays information about summary LSAs for the specified area
or from the specified link-state ID.
Optional. Displays information from a specific link state ID. The value defined
in this field is tied to the advertisement's loop start (LS) type.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
network <ip address>
for more information.
569