ADTRAN AOS Version R10.1.0 Command Reference Manual page 450

Command Reference Guide
show community-list
Use the show community-list command to display any or all defined community lists in the router
configuration. Variations of this command include:
show community-list
show community-list <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
Default Values
No default values are necessary for this command.
Command History
Release 10.1
Release 17.1
Release R10.1.0
Usage Examples
The following example shows two community lists, one of which permits all routes containing community
number 10:67, and another which permits routes containing community number 10:68 and the Internet
community number, but denies routes containing community number 10:45.
>enable
#show community-list
community-list CommList1:
permit 10:67
community-list CommList2:
permit 10:68 internet
deny 10:45
60000CRG0-35E
Optional. Specifies the name of the community list you wish to display. If this
parameter is omitted, all defined community lists will be displayed.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command syntax was changed to remove the ip keyword for IPv6 support
in ADTRAN products.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
450