Table of Contents
Advertisement
Command Reference Guide
ip mgcp call-agent primary <hostname | ipv4 address>
Use the ip mgcp call-agent primary command to specify the primary Media Gateway Control Protocol
(MGCP) call agent host name. Use the no form of this command to remove the specified primary call
agent.
Syntax Description
<hostname | ipv4 address>
Default Values
By default, no primary call agents are configured.
Command History
Release A2
Functional Notes
The ip mgcp call-agent primary command identifies the call agent to the media gateway. Both primary
and secondary call agents can be established, but at minimum a primary call agent is required. If a
connection with the primary call agent fails, call agents will be tried in the order they are entered in the
configuration. For more information regarding call agents and MGCP configuration, refer to the MGCP in
AOS configuration guide available online at
The no form of this command will only take effect if there are no secondary call agents
configured. If secondary call agents are configured, the primary call agent can be modified
by issuing this command with the new host name information.
The primary call agent host name cannot be removed while any secondary call agents are
configured. For more information about secondary call agents, refer to the command
mgcp call-agent secondary <hostname | ipv4 address> on page
Usage Examples
The following example configures the primary MGCP call agent, ca1.company.com:
(config)#ip mgcp call-agent primary ca1.company.com
60000CRG0-35E
Specifies the call agent host name. Host names can be entered as either a
fully qualified domain name (FQDN) or as an IP version 4 (IPv4) address in
dotted decimal notation (XX.XX.XX.XX).
Command was introduced.
https://supportforums.adtran.com
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
(article number 2347).
1046.
ip
1045
Advertisement
Table of Contents
