ADTRAN AOS Version R10.1.0 Command Reference Manual page 264

Command Reference Guide
debug gvrp bpdus
Use the debug gvrp bpdus command to display debug messages showing all GARP VLAN Registration
Protocol (GVRP) configuration messages sent and received on the switch. Debug messages are displayed
(real time) on the terminal (or Telnet) screen. Use the no form of this command to disable the debug
messages.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 8.1
Functional Notes
With GVRP enabled on many ports, this command can produce a lot of output. To display these messages
for individual interfaces, refer to the command
Usage Examples
The following example displays debug messages showing GVRP configuration messages sent and
received on Ethernet interface 0/24:
>enable
#debug gvrp bpdus
2000.07.31 23:15:51 GVRP BPDUS.eth 0/24: TX = (Len:2 LeaveAll) (Len:4 JoinIn Vlan:1) (End) ... SENT
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: RX = (Len:4 Empty Vlan:2) (Len:4 JoinIn Vlan:20) (end)
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: TX = (Len:4 JoinIn Vlan:1) (End) ... SENT
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: RX = (Len:4 JoinIn Vlan:20) (end)
2000.07.31 23:16:00 GVRP BPDUS.eth 0/24: RX = (Len:2 LeaveAll) (end)
#
60000CRG0-35E
Command was introduced.
debug gvrp interface <interface> on page
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
265.
264