ADTRAN AOS Version R10.1.0 Command Reference Manual page 417

Command Reference Guide
show as-path-list
Use the show as-path-list command to display any AS path lists that have been configured in the router,
along with any permit and deny clauses in each list. Variations of this command include:
show as-path-list
show as-path-list <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
Default Values
By default, this command displays all AS path lists.
Command History
Release 10.1
Release 17.1
Release R10.1.0
Usage Examples
In the following example, all AS path lists defined in the router are displayed.
>enable
#show as-path-list
as-path-list AsPathList1:
permit 100
permit 200
permit 300
deny 6500
as-path-list AsPathList2:
permit 400
permit 500
60000CRG0-35E
Optional. Specifies that the command display only the list matching the
specified AS path list name. If not specified, all AS path lists are displayed.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command syntax was changed and the ip keyword was removed for all
AOS products.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
417