ADTRAN AOS Version R10.1.0 Command Reference Manual page 267

Command Reference Guide
debug hmr
Use the debug hmr command to enable debug messaging for either Session Initiation Protocol (SIP)
header manipulation rules (HMR) processes or rules. Use the no form of this command to disable debug
messaging. Variations of this command include:
debug hmr
debug hmr configuration
debug hmr traffic
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
configuration
traffic
Default Values
By default, debug messaging is disabled. When HMR debug messaging is enabled, if neither optional
keyword is specified when the command is entered, then HMR debug messages are generated on any
HMR rule changes that occur.
Command History
Release R10.1.0
Usage Examples
The following example enables debug messaging for HMR policies and their application to SIP traffic:
>enable
#debug sip stack messages
#debug hmr traffic
00:52:13.323 SIP.STACK MSG
00:52:13.323 SIP. STACK MSG
00:52:13.324 SIP. STACK MSG
10.17.142.1:5060;branch=z9hG4bk-2834-1-0
00:52:13.324 SIP. STACK MSG
<sip:256555052@10.17.142.1:5060;tag=2384SIPpTag001>
00:52:13.325 SIP. STACK MSG
<sip:2565550051@10.17.142.252:5060>
00:52:13.325 SIP. STACK MSG
00:52:13.326 SIP.STACK MSG
60000CRG0-35E
Optional. Specifies that whenever HMR configuration changes, debug
messages outlining HMR rule configuration events are generated.
Optional. Specifies that whenever HMR policies are applied to traffic, debug
messages outlining HMR message processing events are generated.
Command was introduced.
Rx: UDP src=10.17.142.1:5060 dst=10.17.142.252:5060
INVITE sip:2565550052@10.17.142.252 SIP /2.0
Via: SIP/2.0/UDP
From: 2565550052
To: 2565550051
Call-ID: 1-2384@10.17.142.1
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
267