Show Vrrp - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show vrrp

Use the show vrrp command to display configuration and operating data for Virtual Router Redundancy
Protocol (VRRP) configurations. Variations of this command include:
show vrrp
show vrrp brief
show vrrp interface <interface>
show vrrp interface <interface> group <number>
show vrrp statistics
show vrrp statistics interface <interface>
show vrrp statistics interface <interface> group <number>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
brief
group <number>
interface <interface>
statistics
Default Values
No default values are necessary for this command.
Command History
Release 16.1
Release 17.1
Release A4.01
Release A5.01
60000CRG0-35E
Optional. Limits the amount of data shown.
Optional. Displays data or statistics for a specified VRRP group on the
specified interface. Group numbers range from 1 to 255.
Optional. Displays data or statistics for all VRRP groups or a specified
group on the specified interface. Specify an interface in the format
<interface type [slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id]>. For example, for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a virtual local area network (VLAN) interface, use vlan 1.
Type show vrrp interface ? for a complete list of valid interfaces.
Optional. Displays statistics for all VRRP groups on all interfaces.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface and the Gigabit Switchport interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
830