ADTRAN AOS Version R10.1.0 Command Reference Manual page 465

Command Reference Guide
show demand
Use the show demand command to display information regarding demand routing parameters and
statistics. Variations of this command include the following:
show demand
show demand interface demand <interface>
show demand resource pool
show demand resource pool <name>
show demand sessions
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interface demand <interface> Optional. Displays information for a specific demand routing interface.
resource pool
<name>
sessions
Default Values
No default values are necessary for this command.
Command History
Release 11.1
Release 17.1
Usage Examples
The following is sample output from the show demand interface command:
>enable
#show demand int 1
Demand 1 is UP (connected)
Configuration:
Keep-alive is set (10 sec.)
Admin MTU = 1500
60000CRG0-35E
Valid range is 1 to 1024. Type show demand interface ? for a list of valid
interfaces.
Optional. Displays all resource pool information.
Optional. Displays resource pool information for a specific resource pool
name.
Optional. Displays active demand sessions.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
465