ADTRAN AOS Version R10.1.0 Command Reference Manual page 1082

Command Reference Guide
ip rtp nat-table-timeout <value>
Use the ip rtp nat-table timeout command to configure the network address translation (NAT) table
timeout for the Realtime Transport Protocol (RTP) packets. Use the no form of this command to return to
the default setting.
Syntax Description
<value>
Default Values
By default, the timeout period is 32 seconds.
Command History
Release A4.01
Usage Examples
The following example sets the NAT session timeout period at 60 seconds:
(config)#ip rtp nat-session timeout 60
60000CRG0-35E
Specifies the timeout period in seconds allowed for an inactive NAT
session. Range is 32 to 900 seconds.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1082