ADTRAN AOS Version R10.1.0 Command Reference Manual page 530

Command Reference Guide
show interfaces cellular
Use the show interfaces cellular command to display configuration parameters and current statistics for a
cellular interface. Variations of this command include the following:
show interfaces cellular <slot/port>
show interfaces cellular <slot/port> hardware
show interfaces cellular <slot/port> profile
show interfaces cellular <slot/port> realtime
show interfaces cellular <slot/port> version
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<slot/port>
hardware
profile
realtime
version
Default Values
No default values are necessary for this command.
Command History
Release 17.2
Usage Examples
The following example displays cellular hardware information for cellular interface 1/1:
>enable
#show interfaces cellular 1/1 hardware
Electronic Serial Number (ESN) : 0x12345678
Preferred Roaming List (PRL) Version : 12345
Mobile Directory Number (MDN) : 0123456789
Mobile Station ID (MSID) : 0123456789
System ID (SID) : 1234
Network ID (NID) : 12
60000CRG0-35E
Specifies cellular interface slot and port number.
Optional. Specifies cellular hardware information is displayed.
Optional. Specifies cellular profile information is displayed.
Optional. Specifies display output is shown in real time.
Optional. Specifies cellular version information is displayed.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
530