ADTRAN AOS Version R10.1.0 Command Reference Manual page 735

Command Reference Guide
show sfp-info interface gigabit-switchport <slot/port>
Use the show sfp-info interface gigabit-switchport command to display small form-factor pluggable
(SFP) transceiver module serial ID information for the specified interface. This command is valid only on
Gigabit Ethernet switchport interfaces.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<slot/port>
Default Values
No default values are necessary for this command.
Command History
Release 17.6
Functional Notes
Fields in the show command output reported as Unspecified are not applicable to the module type. Refer
to the Usage Examples for more information.
Usage Examples
The following is sample output from the show sfp-info interface gigabit-switchport <slot/port>
command:
>enable
#show sfp-info interface gigabit-switchport 0/25
SFP Manufacturer: FINISAR CORP.
Identifier: SFP Transceiver
Connector: LC
SONET Compliance Code: Unspecified
Gigabit Ethernet Compliance Code: 100BASE-SX
Fiber Channel Link Length: Intermediate Distance <I>
Fiber Channel Transmitter Technology: Shortwave laser w/o OFC <SN>
Fiber Channel Transmitter Media: Multi-Mode, 62.5m <M6>
Fiber Channel Speed: 200 MB/sec
Encoding: 8B10B
60000CRG0-35E
Specifies a Gigabit Ethernet switchport interface slot and port number.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
735