ADTRAN AOS Version R10.1.0 Command Reference Manual page 828

Command Reference Guide
show vrf
Use the show vrf command to display the configured VPN routing and forwardings (VRFs) and the
interfaces associated with each one (or a specific VRF). Variations of this command include:
show vrf
show vrf <name>
show vrf interfaces
show vrf interfaces <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
To view secondary IP addresses, use the show running-config command.
Syntax Description
<name>
interfaces
Default Values
No default values are necessary for this command.
Command History
Release 16.1
Release 17.1
Release 17.8
Functional Notes
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured. Therefore, executing the abovementioned commands without
specifying a VRF will only affect the default unnamed VRF.
60000CRG0-35E
Optional. Displays information for only the specified VRF.
Optional. Displays information about interfaces associated with all
configured VRFs.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
The keyword ip was removed from this command.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
828