Show Users - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show users

Use the show users command to display the name (if any) and state of users authenticated by the system.
Variations of this command include:
show users
show users realtime
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Using the realtime argument for this command can adversely affect the performance of
your unit.
Syntax Description
realtime
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Release 10.1
Release 17.1
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 837).
60000CRG0-35E
Optional. Displays full-screen output in real time. Refer to the Functional
Notes below for more information.
Command was introduced.
The realtime display parameter was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
terminal length <number> on
782