ADTRAN AOS Version R10.1.0 Command Reference Manual page 1187

Command Reference Guide
ipv6 dhcp address client limit <number>
Use the ipv6 dhcp address client limit command to specify the maximum number of Internet Protocol
version 6 (IPv6) addresses assigned per client by the Dynamic Host Control Protocol version 6 (DHCPv6)
server. Use the no form of this command to return the maximum number of assigned addresses to the
default value.
Syntax Description
<number>
Default Values
By default, a maximum number of 50 IPv6 addresses can be assigned to a single DHCPv6 client.
Command History
Release R10.1.0
Usage Examples
The following example specifies the maximum number of IPv6 addresses that can be assigned to a single
DHCPv6 client is 75:
(config)#ipv6 dhcp address client limit 75
60000CRG0-35E
Specifies the maximum number of IPv6 addresses that can be assigned to
a single DHCPv6 client. Valid range is 0 to 500. Setting the number to 0
returns the maximum number of allowed IPv6 addresses to the default
value.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1187