ADTRAN AOS Version R10.1.0 Command Reference Manual page 244

Command Reference Guide
debug dot11 packet-events
Use the debug dot11 packet-events command to enable debugging for all 802.11 control protocol packet
events. Debugging can also be limited to a specified interface. Debug messages are displayed (real time)
on the terminal (or Telnet) screen. Use the no form of this command to disable the debug messages.
Variations of this command include:
debug dot11 packet-events
debug dot11 packet-events interface <interface>
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
interface <interface>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 15.1
Usage Examples
The following example activates packet-events debug messages on access point (AP) interface 1:
>enable
#debug dot11 packet-events interface dot11ap 1
#2006.12.23 18:54:25 Dot11 Packet Events: Rx Echo Req from MAC(00:A0:C8:1D:F8:57) AP(1)
2006.12.23 18:54:25 Dot11 Packet Events: Tx Echo Resp to MAC(00:A0:C8:1D:F8:57) AP(1)
2006.12.23 18:54:29 Dot11 Packet Events: Tx Query Req to MAC(00:A0:C8:1D:F8:57) AP(1)
2006.12.23 18:54:29 Dot11 Packet Events: Rx Query Resp from MAC(00:A0:C8:1D:F8:57) AP(1)
2006.12.23 18:54:36 Dot11 Packet Events: Rx Disc Resp from MAC(00:A0:C8:1D:F8:57) AP(1)
60000CRG0-35E
Optional. Activates debug messages for the specified interface. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
debug dot11 packet-events interface ? for a complete list of valid
interfaces.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
244