Show Atm Pvc - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show atm pvc

Use the show atm pvc command to display information specific to the asynchronous transfer mode (ATM)
interface's permanent virtual circuit (PVC). Variations of this command include the following:
show atm pvc
show atm pvc interfaces atm <interface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interfaces atm <interface>
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Usage Examples
The following is sample output from the show atm pvc interfaces command:
>enable
#show atm pvc interface atm 1.1
Name VPI VCI
atm 1.1 0 200
60000CRG0-35E
Optional. Displays the ATM PVC information for a specific PVC. Specify an
ATM interface (valid range is 1 to 1023) or a subinterface in the format
<interface id.subinterface id> (for example, 1.1). Using this command
without specifying an interface will display all information for all ATM PVCs.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Encap Type SC Peak Kbps
SNAP N/A 0
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
Avg/Min Kbps Burst Cells
0 0
Status
Active
418