ADTRAN AOS Version R10.1.0 Command Reference Manual page 623

Command Reference Guide
show ipv6 dhcp
Use the show ipv6 dhcp command to display the Dynamic Host Control Protocol version 6 (DHCPv6)
Unique Identifier (DUID) of the AOS device. The DUID is used to identify the entire DHCPv6 client
device independent of its interfaces and hardware.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 18.3
Usage Examples
The following example displays output from the show ipv6 dhcp command:
>enable
#show ipv6 dhcp
The DHCPv6 unique identifier (DUID) of this device is: 0003000100A0C800611F
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
623