Show Ip Dhcp Binding - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip dhcp binding

Use the show ip dhcp binding command to display the Dynamic Host Client Protocol version 4
(DHCPv4) server client table with associated information. Variations of this command include:
show ip dhcp binding
show ip dhcp binding <ipv4 address>
show ip dhcp binding vrf <name>
show ip dhcp binding vrf <name> <ipv4 address>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ipv4 address>
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 2.1
Release 17.1
Release 18.3
Release R10.1.0
Functional Notes
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured. Therefore, executing the abovementioned commands without
specifying a VRF will only affect the default unnamed VRF.
60000CRG0-35E
Optional. Specifies the IPv4 address of the specified client. IPv4 addresses
should be expressed in dotted decimal notation (for example, 10.10.10.1).
Optional. Displays information only for the specified VPN routing and
forwarding (VRF) instance. If a VRF is not specified, the default VRF is
assumed.
Command was introduced.
Command was expanded to include the vrf parameter and the modifiers
begin, exclude, and include.
Command syntax was changed to remove the hyphen and the server
keyword on ADTRAN internetworking products.
Command syntax was changed to remove the hyphen and the server
keyword on ADTRAN voice products.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
544