Show Interfaces - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show interfaces

Use the show interfaces command to display configuration parameters and current statistics for all
switchport interfaces (or a specified switchport interface). These commands are valid only on switchports.
Variations of this command include the following:
show interfaces
show interfaces description
show interfaces status
show interfaces <interface> extended
show interfaces <interface> switchport
show interfaces <interface> switchport vlans
show interfaces gigabit-switchport <slot/port>
show interfaces gigabit-switchport <slot/port> realtime
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
description
extended
gigabit-switchport <slot/port> Optional. Displays information, such as description, administrative status,
<interface>
realtime
status
switchport
vlans
60000CRG0-35E
Optional. Displays information, such as description, administrative status,
line protocol status, and description for all the interfaces.
Optional. Displays extended medium attachment unit (MAU) statistics.
line protocol status, Layer 3 switching statistics, and description for a
specific Gigabit Ethernet switchport.
Optional. Specifies a switchport interface in the format <interface type
[slot/port | slot/port.subinterface id | interface id | interface id.subinterface
id]>. For example, for a T1 interface, use t1 0/1; for an Ethernet
subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; and for an
ATM subinterface, use atm 1.1. Type show interfaces ? for a complete
list of valid interfaces.
Optional. Displays full-screen output in real time. Refer to the Functional
Notes below for more information.
Displays information, such as description, type, status, virtual local area
network (VLAN), speed, and duplex for all the Ethernet interfaces only.
Displays information, such as description, administrative status, line
protocol status, and description for all the switchports.
Optional. Displays the VLAN membership information for a specific
switchport or series of switchports.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
519