ADTRAN AOS Version R10.1.0 Command Reference Manual page 1037

Command Reference Guide
ip igmp snooping vlan <vlan id> mrouter interface <interface>
Use the ip igmp snooping vlan mrouter interface command to add a static connection to a multicast
router. Use the no form of this command to remove a static connection to a multicast router.
Global Internet Group Management Protocol (IGMP) snooping overrides the virtual local
area network (VLAN) IGMP snooping. If global snooping is disabled, you cannot enable
VLAN IGMP snooping. If global snooping is enabled, you can enable or disable VLAN
IGMP snooping. Refer to
Syntax Description
<vlan id>
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 12.1
Usage Examples
The following example adds Ethernet interface 0/1 to the list of multicast router interfaces:
(config)#ip igmp snooping vlan 1 mrouter interface ethernet 0/1
60000CRG0-35E
ip igmp snooping on page 1035
Specifies a valid VLAN interface ID. Range is 1 to 4094.
Specifies an interface to be added to the multicast router. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type ip
igmp snooping vlan <vlan id> mrouter interface ? for a complete list of
applicable interfaces.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
for more information.
1037