Table of Contents
Advertisement
Command Reference Guide
ip firewall check rst-seq
Use the ip firewall check rst-seq command to enable Transmission Control Protocol (TCP) reset sequence
number checking. Use the no form of this command to disable this feature.
The AOS firewall must be enabled (using the command
stateful inspection firewall to be activated.
Syntax Description
No subcommands.
Default Values
All AOS security features are disabled by default until the ip firewall command is issued at the Global
Configuration mode prompt. In addition, TCP reset sequence number checking is disabled until the ip
firewall check rst-seq command is issued.
Command History
Release 8.1
Usage Examples
The following example enables TCP reset sequence number checking:
(config)#ip firewall check rst-seq
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
ip firewall on page
999) for the
1009
Advertisement
Table of Contents
