ADTRAN AOS Version R10.1.0 Command Reference Manual page 580

Command Reference Guide
show ip policy-class
Use the show ip policy-class command to display the configured session limit and specific host IP
addresses of all current sessions. Refer to
on configuring access policies.Variations of this command include:
show ip policy-class
show ip policy-class <name>
show ip policy-class host-sessions
show ip policy-class <name> host-sessions
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
host-sessions
<name>
Default Values
No default values are necessary for this command.
Command History
Release 3.1
Release 12.1
Release 17.1
60000CRG0-35E
ip policy-class <ipv4 acp name> on page 1058
Optional. Displays specific host IP addresses of all current sessions.
Optional. Displays policy class information for a specific policy class.
Command was introduced.
Command was expanded to include host-sessions.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
for information
580