ADTRAN AOS Version R10.1.0 Command Reference Manual page 722

Command Reference Guide
show running-config probe verbose
show running-config qos-map
show running-config qos-map verbose
show running-config quality-monitoring
show running-config quality-monitoring verbose
show running-config router bgp
show running-config router pim-sparse
show running-config router pim-sparse verbose
show running-config track
show running-config track verbose
show running-config verbose
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
hmr
hmr policy
hmr policy <name>
hmr rule-set
hmr rule-set <name>
ip access-lists
checksum
interface <interface>
60000CRG0-35E
83.
Optional. Displays the current running configuration for Session
Initiation Protocol (SIP) header manipulation rules (HMR).
Optional. Displays the configured SIP HMR policies in the
running configuration.
Optional. Displays the specified SIP HMR policy in the running
configuration.
Optional. Displays the configured SIP HMR rule sets in the
running configuration.
Optional. Displays the specified SIP HMR rule set in the running
configuration.
Optional. Displays the current running configuration for all
configured IPv4 access control lists (ACLs).
Optional. Displays the encrypted message digest 5 (MD5)
version of the running configuration.
Optional. Displays the current running configuration for a
particular interface. Specify an interface in the format <interface
type [slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth
0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface,
use atm 1.1; and for a wireless virtual access point, use dot11ap
1/1.1. Type show running-config interface ? for a complete list
of valid interfaces.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
722