ADTRAN AOS Version R10.1.0 Command Reference Manual page 595

Command Reference Guide
show ip route-cache express
Use the show ip route-cache express command to display the addresses currently being express cached in
hardware. Variations of this command include:
show ip route-cache express
show ip route-cache express count
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
count
Default Values
No default values are necessary for this command.
Command History
Release 17.5
Usage Examples
The following is sample output from the show ip route-cache express command:
>enable
#show ip route-cache express
DESTINATION MASK
----------------------------------------------------------------------------------------
199.0.50.2 255.255.255.255
199.0.45.2 255.255.255.255
198.110.47.2 255.255.255.255
198.50.42.2 255.255.255.255
198.0.46.2 255.255.255.255
198.0.41.2 255.255.255.255
The following is sample output from the show ip route-cache express count command:
>enable
#show ip route-cache express count
Total number of express routes: 26
60000CRG0-35E
Optional. Displays only the total number of entries stored in the route cache.
Command was introduced.
GATEWAY
10.100.43.251
10.100.43.251
10.100.43.251
10.100.43.251
10.100.43.251
10.100.43.251
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
595