Show Ip Ospf Neighbor - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip ospf neighbor

Use the show ip ospf neighbor command to display open shortest path first (OSPF) neighbor information
for a specific interface. Variations of this command include:
show ip ospf neighbor
show ip ospf neighbor detail
show ip ospf neighbor <interface>
show ip ospf neighbor <interface> detail
show ip ospf neighbor <interface> <neighbor id>
show ip ospf neighbor <interface> <neighbor id> detail
show ip ospf neighbor <neighbor id>
show ip ospf neighbor <neighbor id> detail
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
detail
<interface>
<neighbor id>
Default Values
No default values are necessary for this command.
Command History
Release 3.1
Release 9.1
Release 17.1
Release A4.01
60000CRG0-35E
Optional. Displays detailed information on neighbors.
Optional. Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show ip ospf neighbor ? for a complete list of
applicable interfaces.
Optional. Specifies a specific neighbor's router ID.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
and tunnel interfaces.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
572