ADTRAN AOS Version R10.1.0 Command Reference Manual page 272

Command Reference Guide
debug interface <interface>
Use the debug interface command to activate debug messages associated with the specified interface.
Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the no form of this
command to disable the debug messages.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
<interface>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 3.1
Release 6.1
Release 7.1
Release 9.1
Release A4.05
Release A5.01
Functional Notes
The debug interface command activates debug messages to aid in the troubleshooting of physical
interfaces.
Usage Examples
The following example activates all possible debug messages associated with the Ethernet port:
>enable
#debug interface ethernet
60000CRG0-35E
Activates debug messages for the specified interface. Specify an interface
in the format <interface type [slot/port | slot/port.subinterface id | interface id
| interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a
PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type debug
interface ? for a complete list of applicable interfaces.
Command was introduced.
Command was expanded to include the T1 and foreign exchange station
(FXS) interfaces.
Command was expanded to include the foreign exchange office (FXO)
interface.
Command was expanded to include the tunnel interface.
Command was expanded to include the asymmetric digital subscriber line
(ADSL) interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
272