ADTRAN AOS Version R10.1.0 Command Reference Manual page 205

Command Reference Guide
xmodem
verify
Default Values
No default values are necessary for this command.
Command History
Release 17.7
Usage Examples
The following example creates a copy of the file myfile.biz (located on the RAM disk), names the new file
newfile.biz, and places the new file in flash memory:
>enable
#copy ramdisk myfile.biz flash newfile.biz
The following example copies the software file myfile.biz (located on the RAM disk) to a TFTP server:
>enable
#copy ramdisk tftp
Address of remote host? 10.200.2.4
Source filename? myfile.biz
Destination filename? myfile.biz
Initiating TFTP transfer...
Sent 769060 bytes.
Transfer Complete!
60000CRG0-35E
Copies the specified file from the RAM disk (using the XMODEM protocol)
to the terminal connected to the console port. XMODEM capability is
provided in VT100 terminal emulation software, such as HyperTerminal.
After entering the command, AOS prompts for the following information:
Source filename:
Optional. Specifies that a second verification of the new primary or
secondary boot system image is performed after it is copied.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
Specifies the name of the file (located on the
RAM disk) to copy using XMODEM.
205