Show Ip Ospf Interface - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip ospf interface

Use the show ip ospf interface command to display open shortest path first (OSPF) information for a
specific interface. Variations of this command include:
show ip ospf interface
show ip ospf interface <interface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 3.1
Release 9.1
Release 17.1
Usage Examples
The following example shows OSPF information for the PPP 1 interface.
>enable
#show ip ospf interface ppp 1
60000CRG0-35E
Optional. Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show ip ospf interface ? for a complete list of
applicable interfaces.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
and tunnel interfaces.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
571