ADTRAN AOS Version R10.1.0 Command Reference Manual page 606

Command Reference Guide
show ip rtp quality-monitoring interface
Use the show ip rtp quality-monitoring interface command to display the voice quality monitoring
(VQM) statistics gathered from monitored calls on inbound Realtime Transport Protocol (RTP) streams
across interfaces with VQM enabled. These statistics can be sorted by mean opinion score (MOS), jitter, or
lost or out-of-order packets. Variations of this command include:
show ip rtp quality-monitoring interface
show ip rtp quality-monitoring interface <interface>
show ip rtp quality-monitoring interface <interface> detail
show ip rtp quality-monitoring interface detail
show ip rtp quality-monitoring interface <interface> sort-by jitter
show ip rtp quality-monitoring interface sort-by jitter
show ip rtp quality-monitoring interface <interface> sort-by loss
show ip rtp quality-monitoring interface sort-by loss
show ip rtp quality-monitoring interface <interface> sort-by lq-mos
show ip rtp quality-monitoring interface sort-by lq-mos
show ip rtp quality-monitoring interface <interface> sort-by out-of-order
show ip rtp quality-monitoring interface sort-by out-of-order
show ip rtp quality-monitoring interface <interface> sort-by pq-mos
show ip rtp quality-monitoring interface sort-by pq-mos
show ip rtp quality-monitoring interface <interface> summary
show ip rtp quality-monitoring interface summary
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
detail
<interface>
sort-by jitter
sort-by loss
sort-by lq-mos
60000CRG0-35E
Optional. Displays details of all available VQM interface statistics.
Optional. Displays VQM statistics for a specific interface. Specify the
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id]>. For example, for an Ethernet
subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; and for an ATM
subinterface, use atm 1.1.
Optional. Displays VQM interface statistics with the highest amount of jitter
first.
Optional. Displays VQM interface statistics with the highest number of lost
packets first.
Optional. Displays VQM interface statistics with the lowest listening quality
(LQ) MOS first.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
606